TECHNICAL DATA

  • Forces are measured keeping solenoid vertical with plunger run going upwards.
  • Forces are measured in following conditions:
    - Power supply: 100% of nominal current.
    - Coil temperature is as in operating conditions.
    - Forces are expressed in Newton
    (1Kg=9,8 N)
  • ∆T Overtemperature:
    The overtemperature for solenoids exposed to room temperature at 25°-35°C and with 105% of nominal power is 80°C (176°F) maximum
    (Rule: EN 60335-1).
  • Conductors:
    Conductors used for coils are class-F (155°C/311°F) isolated, except for specific customer needs.
  • Dimensions:
    Dimensions values refer to full lenght of solenoid with plunger inserted and closed (run=0).


Power Supply:
- Direct Current or rectified
- Single-phase Alternated Current with embedded rectifier

The Duty Cycle (E.D.):
Is the ratio between ON time and TOTAL cycle time (ON + OFF time).

The E.D. gives for every product the maximum cycle length.
For holding electromagnets the E.D. is 100%

The maximum cycle length (ON time + OFF time) is considered as 300 seconds. This means that for cycle times over 300s 100% ED solenoids must be used.
 


SOLENOID CONFIGURATION:

In order to correctly identify the right solenoid configuration depending on needs, several informations are needed:

  • Stroke in mm
  • (Starting torque) Force at the start of the stroke measured in Newton
  • (Ending torque) Force at the end of the stroke measured in Newton
  • Nominal supply current and AC frequency
  • Number of cycles/hour
  • Duty Cycle (%) as above. If ED value is not as indicated in our technical data, please refer to the value immediately above the value obtained. Solenoids with specific ED values are available upon request.
  • Engagement: pull, push, push/pull
  • Specific working conditions: air temperature, humidity, etc.

TECHNICAL DATA TABLE:

TYPE
ED%
05
15
25
50
99
5%
15%
25%
50%
100%
POWER SUPPLY CURRENT
FREQUENCY
ENGAGEMENT
OTHERS
E58
05
220V
50Hz
PULL
Connecting cables, thermal protection, etc.

The technical data here above is referred to:

Solenoid E5805 220V 50Hz pull, cable


If ordering or for sample request the maximum information over application is required.
Please follow the table as above.

Our Sales office and technical staff is ready to help you to identify the right product for your needs. Don't exhitate to ask!